INSTRUCTIONS
ANALOG ALARM CLOCK WITH BED VIBRATOR MODEL SBA475SS
Features shown on diagrams above:
1. Function Switch
2. Back light Hi/Lo Dimmer
3. Snooze Button
4. Volume Control
5. Flashing Light Display
6. Tone Control
7. Battery Compartment
8. Time Set Knob
9. Alarm Set Knob
10. Back light On/Off
11. AC Power Input
12. Vibrator Input
AC-9V Power Input -
Attach the AC power supply input to the back of clock at AC-9V IN (11) next to the VIBRATOR input, smaller input of the two.
NOTE: IMPORTANT: do not confuse "AC POWER INPUT"(1l) with the "VIBRATOR INPUT"(l2)
Setting the correct time-
1) Turn the Time Set Knob (8) clockwise until hour and minute hands show desired time.
Setting the alarm time-
1) Turn the Alarm Knob (9) clockwise until alarm hand is at the desired time.
Alarm-
To enable the alarm function, slide the "FUNCTION SWITCH" (I) up to the position that you desire to wake to, you can choose "VIB" for bed shaker, "BUZZ" for sound, and "VIB/BUZZ" for both.
NOTE: whichever function you choose to wake to, will be the same function for both alarms. When the alarm sounds, the Flashing Light Display (4) and the back light will flash until the alarm is stopped. Alarm can be shut off by sliding the function switch (1) to off position.
Snooze Operation-
SNOOZE button (3) - press after alarm has sounded. The alarm will be turned off for 4 minutes for extra sleep. The alarm will come back again after 4 minutes.
Shutting Off Alarm-
Alarm can be shut off by sliding the function switch (1) to off position.
Volume Control-
To adjust the "VOLUME", turn the volume wheel (4) located on right side of the clock.
Tone Control-
To adjust the "TONE", turn the tone wheel (6) located on right side of the clock to the desired tone sound.
Bed Shaker / Vibrator- Figure B
1) Attach the bed shaker jack to the side of clock at VIBRATOR input (12).
2) To turn on vibrator slide FUNCTION switch (1) to VIB or VIB/BUZZ position.
3) Place vibrator under mattress or pillow.
Night Light -
The blue back light can be turned on or off by using switch (1O) located at the back of the clock. The brightness of the back light can be adjusted by using the dimmer switch (2) at the side of the clock.
Battery Backup-
To use battery backup, you can install a lo5-volt AA size alkaline battery at the bottom of the clock located under the battery cover (7). Note the back light, vibrator and sound will not operate during power failure, your alarm and time setting will be saved when power is restored.
